Forums Techniques, Tricks, and Tips Dopping, UV cure adhesive

  • douglasmsutherland

    December 28, 2019 at 1:22 am

    Acetone is really the only effective solvent. It requires some soaking, a few hours after you are finished cutting a stone. To transfer I use a small butane torch to heat the dop stick that I am removing. First I wrap the dop and stone to be retained with a wet tissue and then carefully heat the dop I am removing. I use a needle nose to pull off the heated dop. Never had any problem over heating the stone just do not heat the dop too much.

  • jim-jennings

    February 10, 2020 at 6:47 pm

    Thanks for the information.

Log in to reply.