Forums Faceting Machines MDR 300-C Dops

  • MDR 300-C Dops

    Posted by Charles Thaeler on June 6, 2016 at 8:29 pm

    I’m looking for dops for an MDR 300-C faceting machine. They are 1/4″ x 2″ dops with a 1″ “v” groove used to index the dop. If anyone knows of a source please let me know.

    Thanks,
    –Charlie

    gemmakermz replied 2 years, 10 months ago 3 Members · 2 Replies
  • 2 Replies
  • Gregory Hays

    Member
    June 7, 2016 at 4:41 pm

    Charlie,
    I have a MDR 300-C PRO, the dops I found to be as close as the OEM dops are Polymetric. These dops are a little longer than the MDR but if needed you can shorten, they also have the vee groove. I also use the Polymetric transfer jig opposed to the MDR. Contact Zane via their website http://www.polymetricinc.com

    Greg Hays
    The Gem Garden
    San Marcos CA

  • gemmakermz

    Member
    September 4, 2021 at 3:06 pm

    the original MDR i think is gone(out of buisness) if not let me know. i have two one very old and one master when they were last made. i know theres a fellow in california making and sell a machine as a MDR. send me a picture of your dop– the grove and its alignment with the V dop for emerald cuts and it might be possible i can make what you want. need measurements. i’m NOT pricey. regular 1/4″ by 2″ are not a problem and i make them in aluminum and brass.

Log in to reply.