Forums Faceting Machines Question for UltraTec Operators DAD users

  • Question for UltraTec Operators DAD users

    Posted by libram11 on June 23, 2022 at 3:34 am

    How consistent is your DAD? If it sits for 24 hours could yours read .03 less? What is your experience? I’m questioning mine. I set an analog angle dial at dead 0 measured 24 hours later and dead 0 that was 41.00 reads 41.03.

    libram11 replied 1 year, 8 months ago 2 Members · 2 Replies
  • 2 Replies
  • gemmakermz

    Member
    September 12, 2022 at 1:41 pm

    usually, pretty accurate, after a period of use you may have to use the calibration system in the owner’s manual but vibration can cause a slight change to reading, and temperature in the area–they are sensitive. .03 the eye cannot detect and is over kill.

  • libram11

    Member
    November 1, 2022 at 4:42 am

    worked it out with UT my machine was severely out of whack, something happened, but UT took the mast back in fixed it and now it’s dead on.

Log in to reply.