-
Hi again Keith
Just finished a very frustrating few hours trying to make some sense of the program with my extremely limited skills. I searched through our USFG Diagrams and found the angles listed for “European Mixed Cut” by the famous Glenn and Martha Vargas. Decided to use their printed angles as they are available to everyone rather than my own better ones which I worked out many moons ago because their angles are there for any member to try.
Despite many attempts, I was not able to advance through many steps past the first couple. I still could not be certain that I had clicked on an anchor point for any facet that I was trying to render so there was quite a bit of trial and error. Symmetry for a rectangular diagram also caused me some concern for a time.
I’ve tried to attach a pdf of the tiny amount I achieved in several hours and if you can see it you may be able to make some suggestions, please.
Brian in Oz
GemReport_1775703437276.pdf
GemReport_1775703437276.pdf