Forums Faceting Machines Quill alignment / bent? Reply To: Quill alignment / bent?

  • Alan Balmer

    Administrator
    July 13, 2017 at 4:02 pm

    Odd that your “no reply” message is timestamped an hour before the original question.

    Not many people are familiar with the MDR, so you may not get much helpful advice. I would first make sure that it’s not a problem with the dop. Rotate the dop 180 degrees in the quill and see if you get the same measurements. I don’t know how the dial indicator works on that machine. Most indicators measure angle, not distance.

    Anyway, good luck, I hope someone familiar with the machine can answer.