-
Ultra Tec DAD installation and calibration instructions
After an introduction to faceting at the Quartzsite Gem and Mineral Club over the last 2 years, I purchased a V2 with a DAD upgrade at an estate sale. The DAD was loose and not calibrated. I understand there is an instruction manual for the upgrade, and it is also available in PDF. Does anyone have a PDF copy they would share with me?
Thank you in advance,
Joe Arbuckle -
2 Replies
-
Attached is the description of installing and calibrating the DAD. The calibration instruction also starts on page 30 of the V5 manual. It is the same for attaching a DAD to a V2 machine. https://issuu.com/ultratecusa/docs/1607.5cdr_faceting_machine
-
This reply was modified 5 years, 8 months ago by duncanmiller.
-
This reply was modified 5 years, 8 months ago by
-
Thank you. Simple installation and works very well.
Log in to reply.