Reply To: Where do I start? › Forums › Beginner Questions › Where do I start? › Reply To: Where do I start? December 21, 2018 at 4:01 pm #5134 dantmcgowanmac-comParticipant @firstname.lastname@example.org @seanjaniak I am also new to faceting. I am using a Ultratec V5 faceting machine. Regardless of what machine you are using: I found the Faceting 101 series linked to on the Ultratec site to be very helpful. Also the Manual is terrific. I followed the steps outlined in section 6.2 Learning to Facet. Good luck.