I have an old Ultratec V2, that i bought used. I pulled out of storage to get back into faceting after many years. Unfortunately I have no manual for it. The motor sounds ok but the bearings in the table sound horrid. Two questions.
1. Does any one have a manual they would like to part with or know where I could get one.
2. Does Ultratec do repairs on machines this old? It has the blue mast also. I have sent them an e-mail but no response yet. If they don’t has anyone changed the bearings and could walk me through it or am I looking at buying a new one.
At the moment it’s pretty useless.