Forums Faceting Machines Hundredths of a degree on Facetron Protractor

1 reply, 2 voices Last updated by Jeff Kavan 6 months, 3 weeks ago
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #11257

    Jeff Kavan
    Participant
    @jeffkavan

    How do I set my Facetron protractor to cut to hundredths of a degree to accurately cut to a diagram that list those numbers. Like Greg Glenn’s “NightWing”, where it shows to set the protractor to 26.77° or 33.66°?
    I know the Ultra-Tec has a digital angle dial that can show those angles. But since I have a Facetron, how do I pull that off?

    • This topic was modified 7 months, 2 weeks ago by Jeff Kavan.
    #11552

    benrugman
    Participant
    @BenRugman

    Most things won’t require that type of accuracy but may have slightly less refraction. Best is to get close, like width of line less then 26.8 for 26.77 for example. The CAD programs will show it that tight, but your eyes will never know.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.