Forums Faceting Machines Question for UltraTec Operators DAD users

2 replies, 2 voices Last updated by libram11 1 year, 1 month ago
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #8502

    libram11
    Participant
    @libram11

    How consistent is your DAD? If it sits for 24 hours could yours read .03 less? What is your experience? I’m questioning mine. I set an analog angle dial at dead 0 measured 24 hours later and dead 0 that was 41.00 reads 41.03.

    #9494

    gemmakermz
    Participant
    @gemmakermz

    usually, pretty accurate, after a period of use you may have to use the calibration system in the owner’s manual but vibration can cause a slight change to reading, and temperature in the area–they are sensitive. .03 the eye cannot detect and is over kill.

    #9943

    libram11
    Participant
    @libram11

    worked it out with UT my machine was severely out of whack, something happened, but UT took the mast back in fixed it and now it’s dead on.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.