Forums General Discussion Seeking Transfer Jig Advice

Tagged: 

16 replies, 7 voices Last updated by gemmakermz 3 months ago
Viewing 2 posts - 16 through 17 (of 17 total)
  • Author
    Posts
  • #6845

    Allan Beck
    Participant
    @allanbeck

    I have owned 4 Facetron sliding transfer blocks – for a reason. The bodies are made of soft extruded/milled aluminum, while the two slide rods are of a harder anodized material. Wear is inevitable. Also, I sometimes put them in the oven to do a baked epoxy transfer (180 F). The materials seem to expand at different rates, causing the holes to enlarge very slowly until some wobble develops after multiple uses.

    I should check in to Zane’s blocks.

    • This reply was modified 1 year, 2 months ago by Allan Beck.
    #8112

    gemmakermz
    Participant
    @gemmakermz

    this is the block i make and now $15 plus shipping. gemmakermz@cs.com

    Attachments:
    You must be logged in to view attached files.
Viewing 2 posts - 16 through 17 (of 17 total)
  • You must be logged in to reply to this topic.