Forums Tools and Other Hardware Ultra Tec DAD installation and calibration instructions

Tagged: 

2 replies, 2 voices Last updated by joelarbuckle 2 years, 10 months ago
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #7076

    joelarbuckle
    Participant
    @JoelArbuckle

    After an introduction to faceting at the Quartzsite Gem and Mineral Club over the last 2 years, I purchased a V2 with a DAD upgrade at an estate sale. The DAD was loose and not calibrated. I understand there is an instruction manual for the upgrade, and it is also available in PDF. Does anyone have a PDF copy they would share with me?
    Thank you in advance,
    Joe Arbuckle

    Attachments:
    You must be logged in to view attached files.
    #7078

    duncanmiller
    Participant
    @DuncanMiller

    Attached is the description of installing and calibrating the DAD. The calibration instruction also starts on page 30 of the V5 manual. It is the same for attaching a DAD to a V2 machine. https://issuu.com/ultratecusa/docs/1607.5cdr_faceting_machine

    • This reply was modified 2 years, 10 months ago by duncanmiller.
    Attachments:
    You must be logged in to view attached files.
    #7082

    joelarbuckle
    Participant
    @JoelArbuckle

    Thank you. Simple installation and works very well.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.