Wyoming Star › Forums › General Discussion › Wyoming Star 4 replies, 3 voices Last updated by Lowjiber 4 years, 2 months ago Viewing 5 posts - 1 through 5 (of 5 total) Author Posts September 22, 2019 at 10:00 pm #5667 brellan217Participant @brellan217 So this is partly to brag and partly to announce that I will never be cutting the Wyoming Star design again! That was such a challenging cut lol. But the sapphire I cut in it turned out gorgeous. September 22, 2019 at 10:01 pm #5668 brellan217Participant @brellan217 Here’s the stone. Attachments:You must be logged in to view attached files. September 23, 2019 at 4:21 pm #5670 Rick_BrookerParticipant @Rick_Brooker Stone is pretty, you need some new tweezers😊 September 23, 2019 at 9:58 pm #5671 brellan217Participant @brellan217 Lol I can’t think of a good response. I’ll consider some new ones. Thanks for the compliment. I do wish I could get a better pic. Smaller stones are hard for me to get pics of, and that one is only 4mm. I think the size is why that cut was so freaking challenging. If it was a bigger stone it would’ve been easier. September 27, 2019 at 5:04 pm #5688 LowjiberParticipant @Lowjiber Beautiful cut, Tommy. Thanks for the share. Author Posts Viewing 5 posts - 1 through 5 (of 5 total) You must be logged in to reply to this topic. Log In Username: Password: Keep me signed in Enter something special: Log In