› Forums › Tools and Other Hardware › Free ULTRA TEC Parts › Reply To: Free ULTRA TEC Parts

  • gemmakermz

    Member
    February 9, 2022 at 1:34 pm

    i have made a replacement three part pan for my ultra tec. no more pulling down of rubber pan and the extreme mess. i have made a 3D printed pan that is easy to remove and uses two rings one full for regular cutting and one for 90 degree use.
    gemmakermz@cs.com. see second posting below for rest of pictures

    • This reply was modified 4 years, 6 months ago by  gemmakermz.

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .
Secured By miniOrange