• Faceting Machines

  Newbie Needs help with Imahashi Type C facetor

  Posted by Frogfoot007 on April 11, 2026 at 11:53 pm

  Hi everyone! I just acquired an Imahashi Facetor Type C. Even after setting the protractor and locking the angle, there is still some play vertically in the Facet spindle (no side-to-side movement at all). I am told by Imahashi that this is normal. If so, then how do you maintain accuracy while faceting. I have used a Raytaech in the past and had no such issue. Looking forward to learning more from your suggestions. Best regards

  Frogfoot007 replied 5 months, 1 week ago 1 Member · 0 Replies
• 0 Replies

Log In to Reply