› Forums › Faceting Machines › Newbie Needs help with Imahashi Type C facetor

  • Faceting Machines

    Newbie Needs help with Imahashi Type C facetor

    Posted by Frogfoot007 on April 11, 2026 at 11:53 pm

    Hi everyone! I just acquired an Imahashi Facetor Type C. Even after setting the protractor and locking the angle, there is still some play vertically in the Facet spindle (no side-to-side movement at all). I am told by Imahashi that this is normal. If so, then how do you maintain accuracy while faceting. I have used a Raytaech in the past and had no such issue. Looking forward to learning more from your suggestions. Best regards

    Frogfoot007 replied 5 months, 1 week ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .
Secured By miniOrange